Swapper3D Instructions

Add controller to printer (Prusa i3 MK3)

Add screws to the Arduino bracket

  1. Using two(2) M3x10mm Socket Cap screws,
  2. Insert a single screw into each hole of the Arduino bracket (Pink Arrow)

Add arduino bracket to printer

  1. While holding the Arduino bracket above the Z cap,
  2. Align both screws with the holes of the Z cap (Pink Arrow)

Add arduino bracket to printer

  1. Using a 2.5mm Hex end screwdriver,
  2. Tighten both screws (Pink Arrow) which will secure the Arduino bracket to the printer.

Leave a Reply