Purge Test - Extrud...
 
Notifications

Purge Test - Extruder does not hold over purge location  

  RSS

Liam
 Liam
(@liam)
New Member Customer
Joined: 11 months ago
Posts: 2
14/05/2020 9:04 pm  

Purge Test - Extruder does not hold over purge location. it hits the purge mech then the X motor appears to be disabled and it does its purge over mid air. Is there a new gcode needed to tell it to hold location? is it the motor amperage needing increased/springs removed etc?


Quote
Topic Tags
BigBrain3D
(@bigbrain3d)
Supreme moderator Admin
Joined: 12 months ago
Posts: 183
01/06/2020 3:26 pm  

Hi @liam,

make sure you follow the location testing instructions here to determine your unique purge X axis location. It sounds like the extruder is moving too far to the right and you should reduce the X position by .1mm increments until the nozzle is centered over the tack.


ReplyQuote
Liam
 Liam
(@liam)
New Member Customer
Joined: 11 months ago
Posts: 2
01/06/2020 3:32 pm  

Looks to have been an issue with the gcode. I've since sorted it out by sending it via pronterface. 


ReplyQuote
Share: