Notifications
Clear all
Retractable purge mechanism
3
Posts
2
Users
0
Likes
949
Views
Topic starter
03/11/2019 1:48 am
im confused on what i have to do to actually print something with this software. i have setup the side purge mechanism and adjusted the proper purge offset, getting perfect blobs with the test gcode. modified the setting ini file(for palette2), then go into simplycolor3d software and load settings. when i click slice i get a popup tab: Press click to send zip file to the server...and click ok. it says saved on the server. i never get the emailed files. what do i do from here? am i missing something.
06/11/2019 2:00 pm
We are looking into this.
07/11/2019 7:54 pm
The slicer queue was offline while we looked into the issue.
It is now back online. We've fixed the issue. Please try slicing again.