Servo Jitter with runtime firmware on MK3

@moonlightitguy I get the same result

@bigbrain3d Checking in...

@bob-nex

@moonlightitguy

There is a new release of the Octoprint plugin (v0.1.41). Will you please check if it resolves the issue?

@bigbrain3d Exactly the same problem

@moonlightitguy Looks like a mismatch between the github published version and the development version. I think it may be the controller firmware. I will check this out Tues once I receive a new Uno controller from amazon. All our inventory is in the shipping container until Sep 12th...

@bigbrain3d Checking in again.

@moonlightitguy there is a new octoprint plugin version that is tested to fix the bore alignment issue, among other things.