@extrudercat Yes, Tool changes are now handled correctly for gcode during printing. We will proceed with updates to the manual now.

@nightlyh The plugin is nearly complete. Tool changes are working during prints, and manual Swapping is also supported. Palette and MMU specific setti...

@extrudercat That will be a good test 🙂 The plugin is almost ready. Still working on the swap process and testing.

@nightlyh Yes, because the calibration includes screens and settings in Octoprint.

Octoprint Load and Unload insert code is complete. Some work is still needed in Octoprint to handle Tool change commands during prints. This is what ...

Octoprint/Firmware still in progress. We are working on it. It's almost done.

@extrudercat Kickstarter update today.

Completed "Implement locking height step into firmware". moving on to octoprint implementation, Timing the printer extrude with the servo actuation du...

@extrudercat ❤️ GitHub ❤️

@extrudercat Yes, we had an issue with the Octoprint plugin, there is a place in the code that lists the github repo link for the plugin, but there is...

The firmware and octoprint mismatch have been resolved, there are new versions of each on github there was another bug related to the bore alignment ...

@moonlightitguy there is a new octoprint plugin version that is tested to fix the bore alignment issue, among other things.

@extrudercat very exciting 🙂

yes, everyone has a second switch. They wear out after tens of thousands of swaps; we thought it would be less expensive to include another switch whe...

@extrudercat good test, thank you