@bigbrain3D It looks like .stl files previously exported from SC3D as .obj will load. I converted the slab with holes model attached in the last pos...

@bigbrain3d I just discovered another problem. I have a FAB365 model of a Porsche with an annular hole. There is an annular space between the wheel ...

@bigbrain3d Good news/bad news situation for me. Model with holes that I had previously uploaded seem to slice OK. The holes do not fill in. HOWEVER...

@bigbrain3d @cpang Ditto for me. Nothing loads. Tried several different models. Testing the new flat and hole functionality with attached model (sim...

@bigbrain3D What's up guys? Is this the end? Development stopped? No updates in forever. I can't print any Fab365 models. It fills in all the slots ...

@thomas-jensen The print turned out very good. I never liked using infill for transition because sometimes the infill color bleeds through the outer...

@thomas-jensen Interesting, I've never seen that. I can see in the gcode where it is making the short purges. Do you have "Use infill for transition...

@thomas-jensen Try printing the disc with the transition tower and see if you get the same problem. Check your pings, they should be consistent at 9...

@thomas-jensen Thomas, I uploaded a new script to your drive for the side transition. The previous script had a fixed speed for the purge which is w...

@thomas-jensen Sorry you are having problems. I have never used Canvas without Octoprint. Looking at the gcode file you linked, it does not look lik...

@bigbrain3d Good to hear. No major complaints, just not much news on your progress. I've got a laundry list of QOL suggestions, some of which I've p...

@thomas-jensen I uploaded all the .stl's you need and the transition code text files to your google drive. The top right piece is replaced to make r...

@thomas-jensen The text files did not upload in the previous messages. Not sure why I can't upload a text file. I tried pasting the text into the po...