Swapper3D Instructions

Assemble Arduino Controller

Align the Arduino with the bracket

  1. Align the top left and bottom right screw holes of the arduino (orange arrows),
  2. with the pegs on the bracket (yellow arrows),
  3. Press the arduino board onto the pegs

Add Arduino to bracket

  1. Using a 2.5mm Hex end screwdriver,
  2. Screw two(2) M3x10mm Socket Cap screws into the bracket (Pink arrows) at the top right and bottom left corners

Add psu's to arduino bracket

  1. Using a 2.5mm Hex end screwdriver,
  2. and the Ardiuno bracket in the upright position,
  3. with the PSU Input’s on the left(Yellow arrow), and the Output’s on the right (Red arrow),
  4. attach both power supplies to the back of the Arduino bracket (pink arrows),
  5. using eight(8) M3x10 socket cap screws

Leave a Reply